First post so please bear with me. If I’m doing something wrong let me know.
I just purchased 4x T2 Ultra package to replace a couple of SolarCam D1 Lites. I set up two cameras to test before driving 200+ miles to set up at our farm. Have setting to record up to 60 seconds (Intelligent Detection Mode), Track Motion off (another situation below), all notification(Detect All) and far on Detection Sensitivity.
-
the record time is way to short. I walked around yard for 3-4 minutes and instead of 60 second recordings, most are real short.. When I go to events, there are several 10-11 second recording and a few longer. Also notification keep going off every time it starts recording again. Annoying–
-
When I first open app and see the two cameras I click on one to open. I immediately get a small banner top of screen stating there is motion on the camera and records the event even though nothing is moving, then it goes through a routine of moving 1x click to the right and 1x click up, sits there for 4-5 seconds then moves 1x click to the left and 1x back down to original starting location AND it sends a notification and records the motion. I can get it to stop by turning off Motion Detection.
This isn’t happening with my other two cameras I’m hoping to replace. Really annoying sitting here watching TV, etc. and want to view live what’s might be going on and start getting notifications and several event screens.
any suggestions please, We’re leaving Monday to drive down and set these new ones up and if I need to leave Motion Tracking off to correct second problem I’ll need to rethink where I place the cameras.
Thanks much,